Soap-making process

Stage 1

Lye

1. Get the refrigerated water - use scale to measure the needed amount (2.8 oz)
2. Measure the lye
3. Put on breath mask
4. Open up lye container
5. Add lye to refrigerated water

Oils

1. Put the solid oils in the black pot
   • Weigh them as you're adding more, to get the right weight
   • Re-tare the scale after each one
2. Add in the olive oil
3. Heat the black pot to (slowly) melt the solid oils
   • Turn burner to 2 until solids melt, then down to 1 until temperature is reached.

Downtime Get moulds ready Rub castor oil in rigid mold Prepare cooler (if using powdered milk) Use stick to break up powdered milk (before adding in lye) Check lye-water periodically until it has cooled to 110°F Once the lye reaches its temperature, everything happens rather quickly. Stir the mix until it begins tracing, then pour it into the molds.

Cooler arrangement bottom: rectangular tray top: big log-mold with lid small number of cubes for testing

Unmolding

(no unmolding notes at this time)

Trimming

• It's probably a good idea to trim the soap no more than two days after unmolding.
• For cutting into bars, use green "washer" marks for aligning guide
• If log edge is funky (uneven):
  • line the slidy bit flush with edge of cutter for first cut
  • then change to line up with green markings under adjusting washers
• Tog: tall kitchen bags held down by silicone mold bits